Design of gear wear for reselecting equipment ball grinder

What are the causes of gear wear in the ball grinder? How to solve the wear problem? Below we summarize some of the ball mill gear wear reasons and corresponding treatment, hope to help customers.

1, improper selection of lubricating oil, improper use of gear wear of ball mill 

When choosing lubricating oil, we need to pay attention to two aspects. On the one hand is the viscosity of lubricant, on the other hand is the oily nature of lubricant.

2, transmission gear section seal performance poor

The transmission gear size of the ball mill is generally relatively large. According to the relevant design standards stipulated by the country, the gear surface is allowed to have a certain number of errors, so it is necessary to seal the device to ensure the sealing performance between the ball mill gears.

3, ball mill gear hardness is not up to standard cause wear

This is required to increase the hardness of the gear of the ball mill.

One: When buying a ball grinder, you must choose a ball grinder manufacturer with good quality.

Second: when the ball mill gear installation, must be strictly in accordance with national regulations to ensure that the size of the gear top gap, beating, contact, etc. meet the requirements.

Third: In the subsequent operation of the gear, the working state of the gear should be regularly checked. When the wear reaches the upper limit, it should be repaired or replaced in time. If it is found that the surface of the Pinion is rough, it can be manually polished to reduce the roughness of the gear surface; If large gear wear is serious. 

In this respect, our company will be in accordance with the needs and requirements of users to deploy the corresponding ball mill gear, the use of internationally renowned brands for supporting manufacturing.